LiFePO4 battery, Electric Bicycles, ebikes
Electric bike kits or electric bikes
HomeOnline ShopWarranty PolicyMFA QuestionsOur PartnersPhotogalleryContact Us
Electric Bicycle Kits
LiFePO4 Bicycle Batteries
LiFePO4 Car Batteries Q & A
Electric Bicycle Kits

Electric Bike D.I.Y. brushless motor kits for your bicycle tricycle or folding bikes

No licence or Rego needed
Legal kit for Australia for ON-ROADS USE riding anywhere is 24 volts 200 watts. >42kph All our kits use the bicycles existing chain & gears to give 6-9 speeds...This means now you can have a 6-9 speed electric bicycle 

Do i need to pedal always when motor is running?.....NO! You need only pedal when you choose to...all our kits run on a free-wheel system
When using the electric motor you can pedal if you want for extra boost & speeds.....or no pedals and just power along with electric motor....your choice! 
3 way ride system!
pedal only...or...electric only...or...pedal assist with electric

pictured below is our Electric Bicycle 200w-500w D.I.Y. kits 38-50kph

electric bicycle kit

LEGAL KIT BELOW FOR AUSTRALIA
200 watts 24 volts 38kph
OFF-ROAD ONLY KITS BELOW AVAILABLE
  • 250 watts 24 volts 40kph
  • 360 watts 24 volts 45kph
  • 500 watts 24 volts 50kph
  • 650 watts 24 volts 52kph
  • 650 watts 36 volts 60kph
  • 1000 WATTS  48 VOLTS ("BAD BOY") 70kph+

  1000w 48v electric bike kit pictured below 70kph+

1000w 48v contents

 

Simple to follow instructions to follow below...
Takes approx 1-2 hours for easy installation

install 1.jpg
Use crank remover to remove the nut off the cranks.
install 2.jpg
Use crank remover to remove the chain wheel and cranks
install 3.jpg
Use crank remover to remove the chain wheel and cranks
install 4.jpg
The distance between Rear wheel and Button bracket must be at least 60mm for 200w-650w
1000w needs 70mm gap
install 5.jpg
Remove the nut from the button bracket
install 6.jpg
Remove the Axle from the button bracket and replace with the longer Axle.
install 7.jpg
Put the motor’s mounting bracket on button bracket.
install 8.jpg
Put the motor on mounting bracket
install 9.jpg
Put the “ chain wheel on the freewheel crank” on Axle.
install 10.jpg
Add some chain on the all chain ( about 5 notes)
install 11.jpg
Fix the cranks by crank remover

install 12.jpg

Put the chain over motor’s sprocket and adj. the motor to the right high, make sure the nut is fix on the right place

pic of reverse motor install.jpg

Put the chain under motor’s sprocket and adj. the motor to the right high, make sure the nut is fix on the right place
install 13.jpg
Put the motor throttle on the right hand side.
install 14.jpg
Put the gear grip on the left hand side
install 15.jpg
Plug in the throttle’s plug in to motor side controller plug
install 16.jpg
Plug the batters power cord to motor’s power cord.
install 17.jpg
Complete Electric Bike