LiFePO4 battery, Electric Bicycles, ebikes
Electric bike kits or electric bikes
HomeOnline ShopWarranty Policy & MaintainanceMFA QuestionsSpare PartsPhotogalleryContact Us
Warranty Policy & Maintainance

EdealBargains Limited Warranty Policy

Postage:
1.
We are not liable/responsable for lost or damaged articles in post.
2. You must purchase insurrance to protect your items 100%.

12 months warranty on:
1. Electric bike motors with internal controllers & gearbox 200w-500watt models.
2. Electrical bicycle motors 24-48volt 650w-3000watts (External controller models only)
3. LiFePO4 battery systems 12-300Volts 10-300Ah all cell types with BMS installed.
4. Hub motors 200w - 1500w.

90 Days warranty on:
1. LiFePO4 B.M.S. (Battery monitoring system.)
2. LiFePO4 battery chargers 24v-48volts.
3. Twist grip throttles all model electric bike kits.
4. External controllers all models for all sizes 24-48 volts motors.

30 day warranty on:
1. Wiring/plugs/connectors.
2. LiFePO4 or Nimh battery cells without BMS.

To prevent voiding of warranty please be aware of:
1. Please do not leave the electric bicycle or LiFePO4 battery system out in
    the weather or ride in rain to avoid any water damage ocurring.
2. If origainal wiring or plugs are changed in any manor.
3. If 1000-3000w 48v motor kit is used on 26" wheels with other than our stage 2 system or
   (7/8sp internal hub with 23T or above external cogs) please ask if your cog set is correct.
4. If battery systems are dropped or involved in a crash.
5. If battery is short circuited in any manner.
6. Do NOT over-disharge battery below 2.3v per cell with no B.M.S. installed
7. Do NOT leave battery in discharged state...always charge after every use
8. Do NOT leave battery pluged in to motor when not in use to avoid draining battery
9. If fuse is blown from incorrect usage on items (eg: battery chargers.)
10. If external/internal controllers are overloaded or over-heated for any reason.
 
No warranty on these items:
1. Bikes & there accessories (eg: racks, seats, tools etc.)
 
warranty claims procedure:
1. Customer must use a qualified technition to diagnose the faulty part(s) to be repaired.
2. Customer must send back with post costs at customers expense to & from only the part(s) at fault to be repaired/replaced.
3. If the returned item(s) is found to be in working condition a $65 fee will be incurred to the customer.

 
How to maintain your ebike kit or complete electric bikes.
200-500w- approx every 1500-2000km change the gearbox grease.
650-1200w- approx every 1000-1500km change the gearbox grease.
Keep the chain + gears clean & lubed every 150-300km for best results.
Check the nuts & bolts are still nice and tight every once in a while.

How to maintain your battery LiFePO4 & Lithium family systems.
DOD (Depth of discharge)
If you want the maximum recharge cycles your battery can do then only discharge the battery 80% DOD and this will ensure your battery health stays good over longer periods, make sure to never leave any battery in its discharged state as this can damage the cells internally if the voltage is left too low.
These battery systems have NO memory effect so you can charge them at any point during the discharge cycle.
With BMS (Battery Monitoring System) The battery will cut out the power when the volts is at the minimum, this protects against over-discharge, however you must still charge it once this cut-out occurs. You need only charge
the battery after each full discharge use and the BMS will take care of the battery for you.
Without BMS just means you MUST make sure you stop use of your battery once the RED warning led light on your ebikes throttle comes on, By doing this the battery cells will not go below the minimum voltage, Always charge the battery after full discharge ASAP to ensure long life cycles.
Always unplug your battery if it’s not in use for long periods (eg: 3 days+) as all electrics will have a standby drain.
If a battery is left plugged in it can drain the cells in a matter of 5-10 days below the minimum voltage and may damage the cells.
 
Chargers for battery systems
Looking after your charger is easy, just make sure its set to 220/230 or 240 Volts in Australia.
Our 5 Stage chargers are intelligent and will charge your battery without you doing anything after it’s plugged in and turned on.
You need only come back in a few hours and unplug your now fully charged battery and turn the charger off, we recommend not leaving any type of charger plugged into a battery more than 24 hours just to be safe.
Do not leave a charger turned on if no battery is being charged just to be safe again.